Traditional Whirlpool (with Jets)

It is extremely important to clean and disinfect your pedicure spa after each pedicure, after last pedicure of the day, and once a week for overnight cleaning . Regular cleaning will help keep your spa in good working condition. Proper and continuous cleaning will kill harmful bacteria and germs that can cause infection. To clean the pedicure spa, follow these easy steps.

After Every pedicure:

1. Drain water from the spa by turning the drain handle to the "Open" position. Remove all debris .
2. Clean all the surfaces of the basin and all components. Use low-sudsing soap or detergent, and a non-abrasive brush. Remove all visible residue from basin and then rinse with the sprayer.
3. Disinfect all surfaces and components with an EPA registered disinfectant in accordance with your State Board requirements. *EPA disinfectants require 10-minute contact .
4. Rinse off with clean water using the sprayer and wipe all parts dry with clean towel.

After Last Pedicure of the Day:

1. Drain water from the spa by turning the drain handle to the "Open" position. Remove all debris .
2. Remove the following:
   1. Drain Cover
   2. Screen
   3. Jets
3. Remove all debris then wash each component with low-sudsing soap, or detergent, using a soft brush. Disinfect the components as well as the areas behind them with an EPA registered disinfectant. Follow your State Board requirements for disinfecting. Replace all components.
4. Clean all the surfaces of the basin using low-sudsing soap or detergent, and a non-abrasive brush. Remove all visible residue from basin and then rinse with sprayer.
5. Fill basin with clean warm water to the fill line.
6. Pour into the basin; three teaspoons of low-foaming dishwasher crystals (not gel) and 1 ounce of household bleach for up to six gallons of water. 
7. Follow your State Board requirements as they may differ from the above step.
8. Turn on the whirlpool jets and let run for 10 minutes.
9. Turn the jets off and drain water from the basin.
10. Rinse the basin and all other components with clean water using the sprayer.
11. Refill the basin with clean water. Turn the jets on and run for one minute.
12. Drain water from the basin and turn off the whirlpool jets. Then wipe dry with a clean towel.
13. Make a record of the date and time of this cleaning and disinfecting.

Once a Week Overnight Cleaning: 
In addition to the daily cleaning, the following cleaning procedures must be done every week.

1. Follow steps one through seven as listed above as in (After Last Pedicure of the Day).
2. Turn jets off after 10 minutes and let solution sit over night in basin (six to 10 hours).
3. The next morning drain, rinse, and wipe dry with a clean towel.
4. Make a record of the date and time of this cleaning and disinfecting.

CAUTION: 
Cleaning products that contain abrasives can damage the pedicure spa. Use ONLY non-abrasive products to clean the spa.